ABL5 – Software Upgrade / Load 1 RED SYSTEM 1. Switch off the ABL5 2. Mount the Memory card in the memory card slot (do NOT use force) 3. Using a pen. - презентация

1

2 ABL5 – Software Upgrade / Load 1 RED SYSTEM 1. Switch off the ABL5 2. Mount the Memory card in the memory card slot (do NOT use force) 3. Using a pen or similar press the boot switch and switch on the analyzer, Release the switch after 2 seconds. 4. After 120 seconds a acoustics signal sounds, and the message System setup invalid - defaults selected appears. 5. Press continue, remove the Memory Card and check that the ABL starts up correctly.

3 ABL5 – Software Upgrade / Load 2 RED SYSTEM Memory Card Connector Boot Switch

4 ABL5 – Software Upgrade / Load 3 RED SYSTEM Boot switch

5 ABL5 – Software Upgrade / Load 4 RED SYSTEM