Copyright by Hyundai Motor Company. All rights reserved. PA SRS (SIEMENS) - презентация

1 Copyright by Hyundai Motor Company. All rights reserved. PA SRS (SIEMENS)

2 Introduction De-powered Airbag System (General/EUR)

3 OptionGENM/EastEuropeREMARK DRIVERDepoweredOOS PASSENGERDepoweredOOO Side Airbag (FR)--O PAB ON/OFF Switch--O Application O : Option S : Standard Introduction

4 PA Airbag System Inputs and outputs ACU Driver airbag Passenger airbag Side airbags Beltpretensioner Airbag warning lamp Passenger airbag deactivation lamp Crash output to BCM K-Line Battery (+) Front impact sensor Side impact sensor Passenger airbag Deactivation switch ACU Driver airbag Passenger airbag Side airbags Beltpretensioner Airbag warning lamp Passenger airbag deactivation lamp Crash output to BCM Front impact sensor Side impact sensor

5 PA Airbag System Airbag Thresholds Driver Airbag Unbuckled/Buckled PTAirbag Crash Severity No Fire CrashNo Fire Must Fire CrashFire Passenger Airbag Unbuckled/Buckled PAB On-Off Switch On (Enabled)PAB On-Off Switch Off (Disabled) PTAirbagPTAirbag No Fire CrashNo Fire Must Fire CrashFire No Fire Driver Front Airbag Passenger Front Airbag

6 PA Airbag System Airbag Thresholds Driver Seat Thorax and side airbag PTSide airbag Crash Severity No Fire side crashNo Fire Must Fire side crashNo FireFire Passenger SeatPAB On-Off Switch On (Enabled)PAB On-Off Switch Off (Disabled) Thorax and head side airbagPTSide airbagPTSide airbag Crash Severity No Fire side crashNo Fire Must Fire side crashNo FireFireNo FireFire Driver Side Airbag (DSAB) Passenger Side Airbag (PSAB)

7 ACU (Airbag Control Unit) PA Airbag System The primary functions Crash Detection Activation of the front airbags, Side airbags and belt pretensioners Monitoring of the airbag restrain system Indicate system readiness and faults to the drive by means of a fault warning lamp Facilitate servicing capability via a serial diagnostic communication interface

8 DAB (Driver Air Bag) PA Airbag System Resistance: All-fire current: 1.2A for 3ms. No-fire current: single pulse of 0.4A for 10 sec Cyclic test current: 100mA for continuous

9 PAB (Passenger Air Bag) PA Airbag System Resistance: All-fire current: 1.2A for 3ms. No-fire current: single pulse of 0.4A for 10 sec Cyclic test current: 100mA for continuous

10 SPT (Seatbelt Pre Tensioner) PA Airbag System Resistance: All-fire current: 1.2A for 3ms. No-fire current: single pulse of 0.4A for 10 sec Cyclic test current: 100mA for continuous

11 PAD (Passenger Airbag Deactivation) Switch – EUR Only PA Airbag System

12 FIS (Front Impact Sensor) & SIS (Side Impact Sensor) PA Airbag System NameHMC NumberSensorFigures Side Impact Sensor X g, x-axis Front Impact Sensor X g, x-axis

13 Airbag (SRS) Warning Lamp Operations Output (Active fault or historical fault counter is greater or equal to 10) (Normal or historical fault counter is less than 10)

14 PAD Indicator Operations Output ( PAD Lamp operation during Phase-up )

15 Crash Output Output The required command mode implementation is high/low voltage level. When the fire decision is made by ACU, crash output stays low voltage during 200ms like below. (Crash Output Signal)

16 HI-SCAN diagnostic tree Crashing Information Diagnostic Trouble Codes Identification Check Front Crash Information Side Crash Information Driver Crash Information Passenger Crash Information Passenger Airbag Realtime Info Internal faults can´t be erased

17 Inspection chart for trouble symptom Inspection chart for DTCIntermittent malfunction No DTC or cant communicate with Hi-Scan ReoccursDoes not reoccur DTC displayed No DTC DTC displayed No DTC Gathering information from customer Verify complaint Check DTC Record DTC then try to erase them Recheck trouble symptom Check displayed DTC Diagnostic Troubleshooting Flow