By Intersil Corporation. The ICL8038 waveform generator is a monolithic integrated circuit capable of producing high accuracy sine, square, triangular,

Презентация:



Advertisements
Похожие презентации
Unit-3 RECTIFIERS, FILTERS AND REGULATORS :Half wave rectifier, ripple factor, full wave rectifier, Harmonic components in a rectifier circuit, Inductor.
Advertisements

RLC circuit. An RLC circuit (or LCR circuit) is an electrical circuit consisting of a resistor, an inductor, and a capacitor, connected in series or in.
1 Unit-7 FEEDBACK AMPLIFIERS: Concept of feedback, Classification of feedback amplifiers, General characteristics of negative feedback amplifiers, Effect.
Unit -6 AMPLIFIERS: Small signal low frequency transistor amplifier circuits: h- parameter representation of a transistor, Analysis of single stage transistor.
Unit-8 OSCILLATORS: Condition for oscillations. RC-phase oscillator with transistor and FET, Hartley and colpitts oscillators, Wien bridge oscillator,
Single-phase half-bridge inverter. Operational Details Consists of 2 choppers, 3-wire DC source Transistors switched on and off alternately Need to isolate.
Lecture Outline : Production of Induced Force on a Current carrying wire Induced Voltage On A Conductor moving in a Magnetic Field A Linear DC Machine.
1 On A Laboratory, Magnetic Resonance Experimental Set up This is an Animated feature Viewable ONLY with the MS PowerPoint XP Version. Other versions.
M ICROWAVE FET Microwave FET : operates in the microwave frequencies unipolar transistors – current flow is carried out by majority carriers alone Its.
Unit-5 BIASING AND STABILISATION:BJT biasing, DC equivalent model, criteria for fixing operating point, methods of Bias stabilization, Stabilization factors,Compensation.
7/23/2015 1:07:26 AMPulsed NMR by Dr.S.Aravamudhan 1 P -X π/2 At t =0, the end of pulse External Magnetic Field Chemical substance Spin ensemble Z X Y.
Sequences Sequences are patterns. Each pattern or number in a sequence is called a term. The number at the start is called the first term. The term-to-term.
Modeling Sequential Logic Ando KI June Copyright © 2009 by Ando KiModule overview ( 2 ) Typical Sequential Components D Flip-Flop Counter Shift.
Stabilization of the calibration signal frequency Vitaly Stepin Dmitry Stepin Jevgeny Boole.
ELECTRONIC DEVICES AND CIRCUITS Faculty: 1.Shaik.Jakeer Hussain 2.P.Sandeep patil 3.P.Ramesh Babu.
Normal Distribution. in probability theory, the normal (or Gaussian) distribution is a continuous probability distribution that has a bell-shaped probability.
© 2009 Avaya Inc. All rights reserved.1 Chapter Two, Voic Pro Components Module Two – Actions, Variables & Conditions.
Producing Electricity Мозговенко Ольга Петровна Учитель английского языка ЦО 1828 «Сабурово» Москва.
PAT312, Section 39, December 2006 S39-1 Copyright 2007 MSC.Software Corporation SECTION 39 LBCS USING FIELDS AND MICROFUNCTIONS.
CM 4WD (ITM). 2 ADVANGATES Enhanced Vehicle Dynamics - Improved dynamics during acceleration and deceleration - Rapid activation and deactivation - Fully.
Транксрипт:

By Intersil Corporation

The ICL8038 waveform generator is a monolithic integrated circuit capable of producing high accuracy sine, square, triangular, saw tooth and pulse waveforms with a minimum of external components. The frequency can be selected externally from 0.001Hz to more than 300kHz using either resistors or capacitors,. The ICL8038 is fabricated with advanced monolithic technology, using Schottky barrier diodes and thin film resistors, and the output is stable over a wide range of temperature and supply variations. HIGHLIGHTS

VARIABLE AUDIO OSCILLATOR, 20Hz TO 20kHz SINE WAVE OUTPUT BUFFER AMPLIFIERS WAVEFORM GENERATOR USED AS STABLE VCO IN A PHASE-LOCKED LOOP LINEAR VOLTAGE CONTROLLED OSCILLATOR

External capacitor is charged and discharged by two current sources i.e. current source 1(CS1) and current source 2(CS2) CS1 produces a current of I while CS2 produces 2I Current source 1 is always on while Current source 2 is switched on or off by the flip flop. Initial assumption that current source 2 is off.

Capacitor is charged by CS1 with a current I. The capacitor voltage thus increases linearly with time. The comparing voltage for comparator 1 is set at 2/3 of Vcc. Hence when voltage across capacitor reaches this value the flip flop is set Hence CS2 turns on Hence capacitor discharges with a current I, ie the voltage across capacitor drops linearly The comparing voltage for comparator 2 is set at 1/3 of Vcc when capacitor voltage reaches this value it triggers again clearing the flip flop ie turning off CS2 Thus resulting in a triangular wave pin no. 3

The triangular wave output is given to a triangle to sine converter circuit which gives out a sin wave and that output is at pin no.2 triangle to sine converter circuit is a non linear circuit. The output of the flip-flop is given directly to pin no.9 giving the square wave output.

BLOCK DIAGRAM IN DETAIL

Asymmetric wave form can be achieved by connecting resistors at pin no. 4 and 5

Use in Phase Locked Loops Its high frequency stability makes the ICL8038 an ideal building block for a phase locked loop. In this application the remaining functional blocks, the phase detector and the amplifier, can be formed by a number of available ICs (e.g., MC4344, NE562).